1 5/8"
C158" 1 5/8" Ganging • M-158" Low Cost Wire Wound • CF158 Conductive Plastic
| Specifications M-158D |
| Rotation: |
360° mechanical; 320° ± 3° electrical is standard. ± 1° on order |
| Power Rating: |
4 Watts |
| Contact Materials: |
3-wiper Palinery contact brush, precious metal slip ring contacts, coin silver end clips. |
| Rotational Life: |
Over 1,000,000 cycles. |
| Case: |
Precision machined aluminum with blue Aluminlite finish for C-200 and gold Aluminlite finish for BC-200. |
| Shaft: |
2495 to .2498 diameter, precision ground stainless steel, passivated for maximum corrosion resistance. |
| Terminals: |
Standoff type, gold plated brass. |
| Insulation: |
Fungus resistant insulating materials, withstand 1000 volts AC breakdown. |
| Mountings: |
Servo type or single hole mounting with optional, non-turn device. |
| Taps: |
Up to 40 adjustable taps, mounted on universal mounting ring± 0.5° on order FIELD INSERTABLE: TAP –permits p to 40 taps, in 320°, spaced 6° apart in 2" diameter. Special configurations permit taps set zero degrees apart. |
| Clamp Rings: |
Cam action, one-piece stainless steel. Stainless steel socket screws. |
| Double Shaft Extensions: |
Available with special length shafts for coupling to other components. |
| *Independent Linearity: |
± 0.5% standard/. ± 1% an order |
| Resistance: |
± 5% standard. ± 1% on order. |
| Wire: |
Various alloys are used depending on particular application. Generally, wire with temperature coefficient of ± 0.00002 is used. |
* Independent linearity is the deviation in percent of the total measured resistance of the actual resistance at any point, from the best straight line drawn through the resistance vs. rotation curve. The slope and position of the line can be adjusted to make these deviations a minimum.
C158" 1 5/8" Ganging • M-158" Low Cost Wire Wound • CF158 Conductive Plastic
| 
